NZ$200 buys the printed parts only: 2 standard adapters, 2 mirrored adapters, 4 leg sleeves and 4 height adjusters. Timber, plywood and screws are self-sourced. CAD design R02; 14 October 2026.
For one table with a nominal 750 mm finished height. All timber, plywood and screws below are self-sourced and excluded from the NZ$200 printed kit.
| Part | Finished size | Quantity |
|---|---|---|
| Long apron rail | 90 × 45 × 1082 mm | 2 |
| Short apron rail | 90 × 45 × 482 mm | 2 |
| Leg | 90 × 45 × 687 mm | 4 |
| Plywood top | 1200 × 600 × 18 mm | 1 |
Buy 3 straight 2.4 m lengths of 90 × 45 mm timber. Suggested cuts per length: 1082 + 1082; 687 + 687 + 687; 687 + 482 + 482 mm. Allow saw kerf and end trimming; the tightest cutting pattern leaves about 50 mm before kerf. Measure the actual timber before cutting.
Use a 1200 × 600 × 18 mm panel as the top, without cutting it in half.
| Use | Suggested screw | Quantity | Fitting note |
|---|---|---|---|
| Tabletop fixing screws | 8g × 20 mm wood screw | 8 | Two per corner; fit a head inside the 12 mm counterbore. 20 mm length allows about 14 mm penetration into 18 mm plywood through the 6 mm top plate. |
| Apron retaining screws | 8g × 30 mm countersunk wood screw | 16 | Four per corner, through the underside retaining holes. |
| Leg retaining screws | 8g × 25 mm countersunk wood screw | 8 | Two per corner, through the inner leg-retaining holes. |
| Sleeve retaining screws | 8g × 25 mm countersunk wood screw | 16 | Four per sleeve. Use 25 mm to avoid opposing screw tips overlapping in the 45 mm timber section. |
These screw sizes are a proposed assembly BOM derived from the CAD holes, not a tested fastener specification. Check screw-head fit and actual remaining wall thickness before purchase. Pilot-drill timber for your screw manufacturer and wood; snug the screws without crushing the printed parts. Use a corrosion-resistant finish suitable for the chosen timber treatment. No washers or metal levelling hardware are required by the current printed-foot design.
Drill each leg end centrally: Ø22 mm × 35 mm deep for the levelling stud. The current boot has a 50 mm leg socket. At the nominal mid-foot setting, leg cut length = desired tabletop height − 63 mm, with an 18 mm top. Thus 687 mm legs give a 750 mm table. This changes tabletop height, not a certified load rating. Check a complete dry assembly before cutting a custom height.
Bunnings 90 × 45 mm timber, 2.4 m (H1.2 treated option; confirm suitability for indoor use and fasteners) · Bunnings 1200 × 600 × 18 mm untreated plywood · Bunnings timber screws. Local stock and prices vary.
CAD assembly illustration; not a finished-product photograph. Print, fit and load testing pending. This BOM covers a single freestanding table; stacking and printer/AMS clearance are not validated for this version.